When applying plaster to the wall, work from top to bottom and from right to left. Evenly spread the mortar across the wall. Use the brick lines as a guide, start at the bottom of a brick and spread the plaster upwards about two to three bricks. Continue applying the plaster until you’ve covered all of the wall.
How to Plaster Over Brickwork?
Plastering over brickwork is a relatively straightforward task, but there are a few steps that you should take to ensure the best results. To begin, make sure that you have all the necessary supplies, including a plasterer’s trowel, a hawk, a bucket, plaster, a steel float, and a damp sponge.
Before you begin, make sure the surface is dry and clean. If there is any dirt, dust, or debris, use a wire brush to gently remove it. Once the surface is clean, you can start to apply the plaster.
Mix the plaster according to the directions and then scoop it onto the hawk. You can then use the float to apply the plaster to the brickwork, working it into the crevices. Make sure to hold the float at a low angle and use an even, sweeping motion.
Once you’ve applied the plaster to the entire surface, use the trowel to smooth it out. Use the trowel to remove any excess plaster and create a level surface. Make sure to take your time and apply even pressure as you work.
Once the plaster has dried, use a damp sponge to remove any excess residue. Make sure to keep the
Leave a comment