To fix a concrete wall that is spalling, you first need to cut into the concrete around the spalled area. Make the cut about three-eighths of an inch deep with a circular saw. Next, use a hammer and chisel to remove the concrete from the cut area. This step should expose the reinforced steel bars.
How to Repair Spalled Concrete Wall?
Concrete walls can become spalled over time due to weathering, wear and tear, or even accidents. When this happens, the wall can start to crumble and become structurally unsound.
Fortunately, spalled concrete walls can be repaired relatively easily and inexpensively. In this article, we‘ll discuss how to repair spalled concrete walls.
The first step in repairing spalled concrete walls is to determine the cause. If the spalling was caused by water damage, make sure to identify and fix the source of the water issue before attempting to repair the wall.
If the issue is due to wear and tear, then make sure to repair any underlying structural issues before moving on. Once the source of the problem has been identified, the next step is to clean and prepare the wall for repair.
Start by using a pressure washer to remove any dirt, dust, or debris from the wall surface. After the wall has been cleaned, use a wire brush to remove any loose concrete from the area.
Once the wall has been thoroughly cleaned, fill any cracks or holes with concrete patch, and then allow it to dry. After the wall has been cleaned and patched, it‘s time to begin the repair process. Start by mixing a concrete
Leave a comment